why P1137 clutch switch on AT boxster

[porsches2944]

I would probably clear the faults, drive it, and see what comes back. If I recall, I had a tiptronic throw a clutch switch fault once, it ended up being the brake light switch. See if your brake lights work. They use the same part, manual or auto.

With those faults in the picture though, I would probably chase the P0197. That is probably the one that will come back. CAN bus problems don't usually happen unless somebody has been messing with something(radio install, aftermarket accessories, etc). I've definitely had oil sensors go bad. I'm not sure the clutch switch fault will even turn on the CEL.

[jrq986]

Thanks. Ive reset several times and keeps coming back. I bought the oil level and temp sensor (1 pc, I hope just one, passenger side) from pelican. I have removed the intake tubes for access but cant get it out as the intake is on the way. I would need buy the gaskets for the intake (could be rubber ring or what) before I remove the intake for access. That's a little relief knowing P1137 happened to others with auto transmission. Thanks for your input. Lucky I joined the forum.

[jrq986]

ALso Brake lights were good and fuse B7. thanks again