|
James, I use a very sophisticated graphics program that takes a very powerful computer and extensive training. MS Paint. I am Paint certified.
Can this be done with the engine in the car?
I have another question for you. Is it possible to get a wrench on the IMSB bolt nut when the flywheel, clutch and tranny is installed if there were an access port in the bell housing. Or is the flywheel just too close. Is there any recess in the back of the flywheel that might allow access to that nut with a wrench when the flywheel is in a certain position.
__________________
It's all bad
Last edited by Walter White; 01-21-2014 at 05:57 PM.
|
Threaded Mode
