Another IMS bearing thread

[pjq]

James P, your theory seems to be based on the pressure difference that can occur within the tube, why does the simple solution of removing the IMS bearing grease seals non't address this issue?

[Jamesp]

Originally Posted by pjq

James P, your theory seems to be based on the pressure difference that can occur within the tube, why does the simple solution of removing the IMS bearing grease seals non't address this issue?

The lubrication properties of oil and grease are completely different. Splash oil on an open 6204 steel bearing would be dicey at best. The same bearing with grease is fine. The trick is keeping the grease in the bearing.

[southernstar]

Tony, I remember the cars. The Boxster is, of course, much more refined, has much better handling, creates a much better exhaust note, has a much better top, is better assembled and does not have the inevitable rattles of fiberglass on a steel chassis. Cool car though.

Brad

[tonysilver986]

All the above reasons is why I changed to a boxster, apart from one important one, the exhaust noise.
Nothing can compare to the noise of an almost straight through exhaust connected to a thundering V8 lump. The pops and bangs on the overrun is awesome. That's the only thing I miss about the TVR.

So far I have fitted a double din touchscreen cd/rad/satnav/dvd player, sports back box with sports headers ready to go on soon. New discs/pads and clear rear lights which I really like

[recycledsixtie]

Originally Posted by tonysilver986

All the above reasons is why I changed to a boxster, apart from one important one, the exhaust noise.
Nothing can compare to the noise of an almost straight through exhaust connected to a thundering V8 lump. The pops and bangs on the overrun is awesome. That's the only thing I miss about the TVR.

So far I have fitted a double din touchscreen cd/rad/satnav/dvd player, sports back box with sports headers ready to go on soon. New discs/pads and clear rear lights which I really like

I have sent you a pm.

[Walter White]

Here is another priority for my IMS bearing replacement. Alignment.



If this flange were installed as-is, the bearing could very possibly be placed out of alignment, caused by the high spot on the bolt tang.
After I install the bearing into the IM shaft, I am going to measure the distance from the bearing outer race to the surface that the flange bolts onto on the case to make sure the bearing is parallel with the case surface.
Then I am going to take the seal off the flange and try to slip it into place to check that all the bolt tangs on the flange touch the case surface. If one or two tangs are high, not touching, I'm not sure what to do then but I guess I'll figure it out.

Edit: Better yet, to check that the bearing seating surface inside the IM shaft is parallel to the case surface, I will take a little off a 6204 outer race outside surface so that the race will slide into the IM shaft bore easily. Then I can check for parallel of the race to case surface, before installing the actual bearing. But I will check the final installation of the bearing too.