Cowl Panel Covering molding/gasket search

[mistermac99]

Originally Posted by Meir

no no no.
no glue.
the rubber goes on the plastic part in a very particular angle.
it took me sometime to figure it out. just "play" with it. take your time, and be patient with it.

If I get the gasket on the correct way, does it stay on correctly without falling off during installation?

[Meir]

Originally Posted by mistermac99

If I get the gasket on the correct way, does it stay on correctly without falling off during installation?

yes.
and PM sent.

[BrokenLinkage]

Yes. The rubber gasket's forward-most edge sort of clamps onto the inner plastic ledge of the cowl, as I recall, where it will stay while you install the cowl.

[mistermac99]

I got the gasket on this evening. The middle part was easy, but for some reason, both ends were kind of strange. Porsche could have done a better job with that.

It seems to stay on okay except for the ends, so I put small pieces of tape underneath at both ends to hold the gasket in place until I have time to pull the old one off and replace with the brand new cowl panel cover, and the new gasket.

Thanks for all the feedback!!