Custom Center Caps for Porsche Wheel [from CAD, prototyping to finish] - 986 Forum - The Community for Porsche Boxster & Cayman Owners

Toolpath Pic 1: Turning/boring the inside (ID) of the cap + threading a M52*1mm
Toolpath Pic 2: Turning/profiling the outside (OD). Made a quick fixture with a OD thread that fit the M52*1
Toolpath Pic 3: Milling/drilling using a 8mm flat endmill then fininshing the floor using a bullnose 8MMR1 cutter
Toolpath Pic 4: Milling/4axis, Multiaxis toolpath going around the clips.

jaykay · 01-28-2017, 07:53 AM

Quote:

Originally Posted by Nine8Six

Dude I think its what they put in the cheese these days :/

Already at balancing this assembly Jay. Doing the 1800RPM(223km/hr) currently. Hopefully be done with counter-weighting the center/badge by tomorrow so I can (finally) send this to CAM. I'm actually really eager to see them myself.

Secret: good tools man... makes for an easy job. Prototypes are always spot on

新年快乐!

Ahhhhh the old balance feature hidden under the crest trick.....my brain is too dull these days to have figured this out was wondering about this on the CGT models.

Have a great celebration!