Hello guys!
After more than a year behind the wheel of a 986... I still struggle sometime with rev-matching downshifts...
I looked at pedal extensions, and, well, Porsche prices :/
So, I made mine:
It's just a plastic prototype, and I used the screws I had laying around... And I had to cut a piece off it... so it looks terrible from behind!
I haven't tested yet (I did a test with piece of wood taped to the pedal... and it worked great).
I'll work on it a little to make it easier to install, with the right screws...
This one is made the same way I made the plenum, but can be made out of stainless steel and steel for not much (around 30$) while a plastic one should be around 10.
Tell me what you think! (except if you say that the fixation I used looks ghetto, I already know ^^)
Ben.
Ben006 
Threaded Mode
