DIY Remote Range Improvement

[Burg Boxster]

Originally Posted by Fintro11

Once you have the sun visor removed, Grap the top of the A pillar and give it a good pull, 00+ will need to use more force than the earlier cars.

Nice write up Fintro.

Suggestion... Instead of pulling really hard at risk of breaking A-pillar trim, merely reach down behind w/ a long screw driver and release clip at dash level holding in and it easily comes up and out.

VERY IMPORTANT TIP: Do NOT over tighten the T-30 screws upon re-install or you'll have another DIY to perform... http://986forum.com/forums/general-discussions/17135-convertible-top-receiving-latch-plate-thing.html

[Fintro11]

Originally Posted by Burg Boxster

Nice write up Fintro.

Suggestion... Instead of pulling really hard at risk of breaking A-pillar trim, merely reach down behind w/ a long screw driver and release clip at dash level holding in and it easily comes up and out.

VERY IMPORTANT TIP: Do NOT over tighten the T-30 screws upon re-install or you'll have another DIY to perform... http://986forum.com/forums/general-discussions/17135-convertible-top-receiving-latch-plate-thing.html

I tried reaching in with a screw driver but i could not get it in the right position, I was about to get the sludge hammer next :dance: