Footwell Subwoofer Enclosure DIY

[Dlirium]

Off the chart! When you said you would post plans, i was thinking some measurements on the back of a napkin :-)

One question - the face doesn't seem to have any measurements listed. Not being familiar with "registration lines", are these a standard distance? I could probably guess, but thought I'd ask...

Thanks again for this great work!!

[Benjamin]

Originally Posted by Dlirium

Off the chart! When you said you would post plans, i was thinking some measurements on the back of a napkin :-)

One question - the face doesn't seem to have any measurements listed. Not being familiar with "registration lines", are these a standard distance? I could probably guess, but thought I'd ask...

Thanks again for this great work!!

Thanks. I work on CAD a little bit for work and it's just easier for me to draw out plans using a mouse instead of a pencil. It's a lot easier to figure out angles and distances that way and you can easily rescale everything.

The registration marks are not a standard distance apart, they are just there so that when you print out all 6 panels, you have several lines to use to line up adjacent pages. If you hold those pages up to the light, several lines should overlap perfectly. It's just a way to know that each page isn't twisted, or too close/far from the next one. The lines from each page don't abruptly end, they run long and overlap the same lines on the adjacent page.

(I just read the above paragraph to my girlfriend and she looks puzzled).

[Benjamin]

I'll update the .pdf on Monday, but here are at least some basic dimensions for the face:



I know the outside lines didn't change, and am 99% sure the hole is in the same place in this drawing as in the final.

[Dlirium]

Originally Posted by Benjamin

I'll update the .pdf on Monday, but here are at least some basic dimensions for the face:



I know the outside lines didn't change, and am 99% sure the hole is in the same place in this drawing as in the final.

Ah, got it! I didn't realize it was meant to be printed out and used as a template!! that makes it even easier!!

Thanks again, will be building this soon...awesome design...