Irractic Idle - Cleaning Throttle Body

[aussieboxy]

5. Replace the trottle body with the 4 hex bolts. Careful not to overtorque as they are into a metal sleve in plastic. Just hand tight then nip them up.

6. Replace intake tube. It can be a little difficult to get the end back on the throttle body so I used just a little WD 40 or CRC on the inside lip to help it slip back on.

7. Tighten both end clamps of intake tube & start her up.

8. Replace engine cover & return hood to normal position & your done.

Quite easy to do and should only take you about an hour or so from do to wow.

If you have any questions PM me.

Good luck.