Replacing the ignition switch

[JFP in PA]

Originally Posted by LoneWolfGal

Question: Since the switch is part of the electrical system, is it necessary to disconnect the battery first?

That would be a very good idea.

[LoneWolfGal]

Originally Posted by JFP in PA

That would be a very good idea.

Then I'm glad I disconnected the negative terminal and insulated the cable end in a plastic bag. Thanks for the confirmation.

[LoneWolfGal]

I managed to get the task half-finished before I had to knock off for the day to attend to something else. First, I removed the driver's side vent, which indeed provides better access to the switch. Then I unplugged the wiring harness connector from the back of the switch and had just enough time remaining to loosen one of the set screws (see photo). Even with access through the vent, getting a small screwdriver on those screws is a challenge, I kid you not. Wrapping things up will have to wait until tomorrow. I hope it's not a godawful thrash to get it back together.