Misfires and flashing CEL

[safesaxbdd]

Thanks - I will try to clean out the TB/plenum and intake. I did notice a slow leak develop overnight from where the bell housing is, sadly, so may be toast.

[ecp]

Originally Posted by safesaxbdd

Thanks - I will try to clean out the TB/plenum and intake. I did notice a slow leak develop overnight from where the bell housing is, sadly, so may be toast.

I wouldn’t rule out the engine being toast just yet. The rms could have been in it’s way out undetected and the failure just made it worse. I looked at the post jake raby made about the two modes of failures and from everything you’ve described minus the rms, sounds like failure mode 1.

When mine failed it was actually a combination of the two modes he described. It whined really loudly, tons of smoke, ran like junk, no CEL but my seals were okay. I had just replaced the rms two months prior to its failure.

Personally I think it’s well worth pursuing getting that leak fixed and trying to get it back on the road, if you’re inclined to get your hands dirty.

[safesaxbdd]

Thanks, ecp. Fingers crossed it's ok. I actually couldn't get the throttle body off - the bolts wouldn't come loose even after I sprayed free-all on them - so tomorrow I'll let another mechanic take a look and see what's what.

[ecp]

Originally Posted by safesaxbdd

Thanks, ecp. Fingers crossed it's ok. I actually couldn't get the throttle body off - the bolts wouldn't come loose even after I sprayed free-all on them - so tomorrow I'll let another mechanic take a look and see what's what.

You can leave the throttle body on the plenum. Just undo the AOS hose that goes onto the plenum, the rubber boots that attach the plenum to the runners and the one bolt that mounts the tb to the engine. It’s better to do it this way so you don’t compromise the seal between the throttle body and plenum and it gives much better access to the intake runners to get the oil out