IMS question!!

[Eric-986]

I broke two of the pullers shown in the Burner video on my dual row IMS bearing, and ended up spending the $200 for the IMS tools. If you watch on e-bay, the tools show up. Where are you located?

-Eric

[Homeoboxter]

You can use a blind hole bearing puller, worked well for me. It has to be perfectly centered and it should come out.

[rbayer]

Originally Posted by Eric-986

I broke two of the pullers shown in the Burner video on my dual row IMS bearing, and ended up spending the $200 for the IMS tools. If you watch on e-bay, the tools show up. Where are you located?

-Eric

I am in North Houston. weve broken a 3 tooth bearing puller the first time. got it to the point the IMS is ready to come out the right way. weve actually been watching that exact video line up. im going to try with said bearing puller bc weve already rented it but will also keep yalls suggestions in mind. thank yall for yalls feedback, was really worried for a bit i shot myself in the foot. did a full rotation when putting the car in TDC and the cams lined up, so i think timing is still o.k.