996 on Wheeler Dealers tonight

[cas951]

Anyine know which IMS bearing they used?

[JFP in PA]

Originally Posted by cas951

Anyine know which IMS bearing they used?

LN IMS Solution dual row. Unfortunately, they skipped more steps than they showed, so is was a bit of a "Reader's Digest" version of how it is done.

[JayG]

Originally Posted by JFP in PA

LN IMS Solution dual row. Unfortunately, they skipped more steps than they showed, so is was a bit of a "Reader's Digest" version of how it is done.

you expected more?

[husker boxster]

Originally Posted by JayG

you expected more?

It would have been nice if they'd have shown Ant locking down the engine before the removal. I understand they only have 40 some min of content and can't show everything, but the could have cut out a min or two of them driving around mountain roads to make room for a key step in the process.

[flmont]

And since Wheelers used the IMS Solution its now 20% off at LN,. until the 19 th or 20th of April !!

[nickg]

Originally Posted by flmont

And since Wheelers used the IMS Solution its now 20% off at LN,. until the 19 th or 20th of April !!

where do you see this?

[JFP in PA]

Originally Posted by JayG

you expected more?

Stuff like this is exactly why so many DIY's go horribly wrong. Over the years, we have seen more than our share of installs that when south simply because they did not follow the explicit instruction steps. If you are going to publish or post short cut videos, you should take ten seconds to explain that time constrains prevent showing all of the necessary steps, if for no other reason than to save some totally unnecessary grief and expense.