Quote:
Originally Posted by Nine8Six
Exterminate the halogen! Yay!!
1. Can't remember but it was quite a bit of material and needed pretty custom art to get them there and somehow closely aligned with the car.
2. Reseal with sealant, if you don't fancy cutting a plate out of sheet metal or thin sheet of aluminum. If memory is good
3. I use Butyl on the headlights that I personally service here, however I (and most, I think) do recommend silicon-based sealant (much stronger). Later can also be removed but require considerable heat and lot more wrist-energy :/
|
Hey Nine, yes, extracting of the halogen. Definitely required far more material than I thought but WORTH EVERY HID GLOW. I was thinking of using maybe aluminum tape on the inside. I thought about using the Butyl and aluminum foil on the back side to seal up as well.
I think I will go with the Butyl as well.
Last question. What do you use after the headlight is out of the oven to hold headlight tight so it seals?
Threaded Mode
