|
Fired up the car today - started great but once warmed up it would not idle properly and was tough to start.
Borrowed a OBD code reader from a buddy
Had 3 codes in - 2 were related to O2 sensors
1 was the crank sensor
Cleared codes - Ran car and let it quit a couple times - No CEL came on
Put OBD on again - Crank sensor failure code.
Did a little reading on Pelican site to see how tough it is to change and if it could be done with trany in - Seems it can be changed without trany removal - Just a bit of a crap job.
A few of the people who wrote in about the sensor failure seem to be having the same issues as I have - a couple were right after clutch changes also.
Will order in a new one tomorrow and may take a night this week and put it in.
Hope this is it.
Again - Thanks for all the help and the push to get a code reader.
Will be purchasing one of my own soon.
|
Hybrid Mode
