|
Ok so i used some leftover vinyle wrap and I removed the original silver vinyle overlay. I did not remove the needle because I didn't want to deal with the recalibration of the speedo. So before I placed the strips on the gauge I made sure they were the same width. I left them longer then the gauge and then proceed to set them straight. Once they were straight I began to trim the vinyle to a place where they looked good. So the only thing that I pre cut before placing them in there was there width and made sure that their edges were straight.
So the rounding of the top was all visual. at first i tried a protractor but it was not round enough for me so I went freestyle with my scalpel.
I am not going to do the other two because I like the contrast and the stripes in the middle are to draw the attention to the rev counter. Maybe later on I may remove the silver overlays to make the red lines stand out more but for now I am leaving them as is.
|
Threaded Mode
