Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

Post Reply
 
LinkBack Thread Tools Display Modes
Old 11-20-2011, 04:01 PM   #1
Registered User
 
Join Date: Oct 2011
Posts: 43
Rigth side marker fuse

I noticed that my right side tail light was out. I tested the light bulb by switching it from side to side and the bulb turned out to be ok.

I finally tracked it down to the right side marker fuse (I think position A3). Trouble is, every time I replace it, immediately blows immediately.

I am not a sparkie by any stretch of the imagination. Where (and how) do I start looking?

crumbum is offline   Reply With Quote
Old 11-20-2011, 04:25 PM   #2
Matt
 
MileHighBoxster's Avatar
 
Join Date: Nov 2011
Location: Colorado
Posts: 284
You, or someone, will have to start tracing wiring until you find the short.
MileHighBoxster is offline   Reply With Quote
Old 11-20-2011, 04:33 PM   #3
Registered User
 
Join Date: Oct 2011
Posts: 43
Quote:
Originally Posted by MileHighBoxster View Post
You, or someone, will have to start tracing wiring until you find the short.
I realize this sounds very stupid, but how do I do that?
crumbum is offline   Reply With Quote
Old 11-20-2011, 06:12 PM   #4
Matt
 
MileHighBoxster's Avatar
 
Join Date: Nov 2011
Location: Colorado
Posts: 284
That's not stupid. I wouldn't know where to start on a vehicle like a Boxster. If I was to try, I guess I would start from the effected turn signal and work forward from there. Otherwise I would drop it and the keys off at my dealership and let them figure it out.
MileHighBoxster is offline   Reply With Quote
Old 11-20-2011, 07:23 PM   #5
Registered User
 
Join Date: Mar 2011
Location: Vancouver Isld , B.C.
Posts: 69
Garage
Look for water or corrosion in the light socket first , then check any wiring
connection points on that circuit.

Good luck,
Nick
__________________
'99 Boxster Arena Red
nnewell is offline   Reply With Quote
Old 11-21-2011, 06:24 AM   #6
Opposed to Subie Burble
 
Overdrive's Avatar
 
Join Date: Mar 2007
Location: Central CT
Posts: 1,197
Garage
I think this is a bit better at explaining it than I might be. I wouldn't recommend following the directions to the letter, especially if you're not confident in your skills in dealing with electrical wire maintenance, but also because this is very general and you shouldn't go chopping up your car's wires. You can at least strat tracing before you drop the car off to a specialist, possibly isolate the general area of the short, and understand what you're actually looking for.

How to Find Electrical Shorts | eHow.com

EDIT: One thing I can definitely say that's mentioned in there is don't go hunting with the battery still connected. You'll fry your meter. And you don't need just an ohm-meter, just go get a multi-meter if you don't already have one, and ensure that it can read resistance in ohms, and you're good.
__________________
-O/D

1997 Arctic Silver Boxster, 5-spd
IMSR + RMS
Robbins glass window top
Overdrive is offline   Reply With Quote
Old 11-21-2011, 04:39 PM   #7
Registered User
 
Join Date: Oct 2011
Posts: 43
I removed the side marker and the tail light circuit board tonight and put in a fresh fuse in.

When I switched the light switch on and POP.

%%$&* !!!!!!!

So, I am assuming that the short is somewhere in the wiring harness.
crumbum is offline   Reply With Quote
Old 11-21-2011, 04:52 PM   #8
Registered Boxster abuser
 
healthservices's Avatar
 
Join Date: Oct 2011
Location: socal
Posts: 1,014
You really need a wiring diagram to help you map out what to do.

Basically you will find out what is in that circuit, unplug and check those connections, follow the affected wires until you find your short.
healthservices is offline   Reply With Quote
Old 11-21-2011, 05:07 PM   #9
Registered User
 
Join Date: Nov 2006
Location: In the garage...
Posts: 1,702
try using the parking light for side of road (European set up for narrow streets) and see if fuse blows. If it doesn't, wiring is probably good and headlight switch is likely bad (very possible as they are known to crap out).

Good luck and see owners manual if you don't know what I'm referring to.

Burg Boxster is offline   Reply With Quote
Old 11-21-2011, 05:34 PM   #10
Registered User
 
Join Date: Oct 2011
Posts: 43
Thanks guys,

I downloaded the wiring diagram. It shows only the side marker (right side and right rear) on circuit breaker A3.

With all components removed from that circuit, it still craps out on me.

Will the light switch only affect the right side circuit?
crumbum is offline   Reply With Quote
Old 11-22-2011, 05:52 AM   #11
Opposed to Subie Burble
 
Overdrive's Avatar
 
Join Date: Mar 2007
Location: Central CT
Posts: 1,197
Garage
Did you try the parking light check like Burg suggested?
__________________
-O/D

1997 Arctic Silver Boxster, 5-spd
IMSR + RMS
Robbins glass window top
Overdrive is offline   Reply With Quote
Old 11-22-2011, 02:28 PM   #12
Registered User
 
Join Date: Oct 2011
Posts: 43
Ok, I just went after a fresh batch of fuses and popped one in. When I turned the light switch to Park, the right side marker fuse (A3) popped again.

I still had the side marker and the tail light circuit off.

Does this mean that the switch is suspect? Or could it still be somewhere in the harness?
crumbum is offline   Reply With Quote
Old 11-22-2011, 06:20 PM   #13
Registered User
 
Join Date: Nov 2006
Location: In the garage...
Posts: 1,702
Is headlights pod still in place? Why not pull it out and try again...

Did you turn it to the parking lights (one click clockwise) or to park setting counterclockwise?

Last edited by Burg Boxster; 11-22-2011 at 06:22 PM.
Burg Boxster is offline   Reply With Quote
Old 11-22-2011, 06:40 PM   #14
Registered User
 
Join Date: Oct 2011
Posts: 43
Quote:
Originally Posted by Burg Boxster View Post
Is headlights pod still in place? Why not pull it out and try again...
I dont understand. Headlight pod? You mean I should remove the headlight? I can certainly do that, however I was focusing on the items on the A3 circuit.

Quote:
Originally Posted by Burg Boxster View Post
Did you turn it to the parking lights (one click clockwise) or to park setting counterclockwise?
I turned the light switch two notches counter-clockwise to the park setting.
crumbum is offline   Reply With Quote
Old 11-23-2011, 05:17 AM   #15
Opposed to Subie Burble
 
Overdrive's Avatar
 
Join Date: Mar 2007
Location: Central CT
Posts: 1,197
Garage
Two notches CCW is the parking lights for the left. One would be for the right, based on the arrows on either side of the "P" symbol. The switch lights the side marker and taillight of the respective side you set the switch to. Also, these only function when the car is not running.

And I believe he was indeed referring to you pulling out the headlight when trying. Remember, you're trying to isolate the source of your short.
__________________
-O/D

1997 Arctic Silver Boxster, 5-spd
IMSR + RMS
Robbins glass window top
Overdrive is offline   Reply With Quote
Old 11-23-2011, 06:45 AM   #16
Registered User
 
Join Date: Oct 2011
Posts: 43
Quote:
Originally Posted by Overdrive View Post
Two notches CCW is the parking lights for the left. One would be for the right, based on the arrows on either side of the "P" symbol. The switch lights the side marker and taillight of the respective side you set the switch to. Also, these only function when the car is not running.

And I believe he was indeed referring to you pulling out the headlight when trying. Remember, you're trying to isolate the source of your short.
Even more curious that it would blow the right side circuit. Unless it blew as I moved it past the first notch.

I will remove the headlight and keep looking
crumbum is offline   Reply With Quote
Old 11-24-2011, 08:19 PM   #17
Registered User
 
Join Date: Oct 2011
Posts: 43
Ok, I found the problem. After A LOT of troubleshooting, I found that the front park light bulb had burnt out and fused against the socket. That caused the short.

The bulb that I pulled out of there looks strange though. I have not seen it before. Looks like the following:


I see that they are available on ebay, but cannot seem to find anything else about them. Anybody know?
crumbum is offline   Reply With Quote
Old 11-25-2011, 03:29 AM   #18
Registered User
 
Join Date: Nov 2006
Location: In the garage...
Posts: 1,702
Thus my suggestion to remove headlight pod...glad you found source. Those are crap aftermarket LED bulbs. Without a proper resistor and heat sink, they were bound to overheating and cause a problem one way or anothet. Find correct replacement bulb using either guide in any parts store or by going to:

OSRAM SYLVANIA - SYLVANIA Home

Select consumer products, auto lighting, replacement guide and then select your car from the drop down menus.

Good luck
Burg Boxster is offline   Reply With Quote
Old 11-25-2011, 03:58 AM   #19
Registered User
 
Join Date: Nov 2006
Location: In the garage...
Posts: 1,702
PS- it goes w/o saying...pull the one in the drivers side too before it causes damage...
Burg Boxster is offline   Reply With Quote
Old 11-25-2011, 07:29 AM   #20
Opposed to Subie Burble
 
Overdrive's Avatar
 
Join Date: Mar 2007
Location: Central CT
Posts: 1,197
Garage
+1, good to see that you found your problem without having to send it off to a dealer or mechanic...and before you ate any more fuses.

Some day, someone will make an affordable LED lighting setup that is truly plug-and-play, but until then, people get what they pay for, and whoever dropped those in there before you took the super cheap way out.

Hey, there's another DIY for you, crumbum, go get yourself a soldering iron and make your own LED driving lights.

__________________
-O/D

1997 Arctic Silver Boxster, 5-spd
IMSR + RMS
Robbins glass window top
Overdrive is offline   Reply With Quote
Post Reply


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 01:28 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page