Need to Drop a Boxster motor a few inches Help!

[pk2]

Hello,

How do I temporarily drop my engine a few inches. I’ve got a TPC super charger that’s got one pipe from the “below board” sc up to the top deck. TPC claims 100% bolt in. Everyone I met spent hours trying to fit the pipe in ( I did and gave up).

A knowledgeable guy said “just drop the engine a few, no prob”. Makes sense to me, but how?

I’ve yanked and dropped lots of engines, can’t imagine this one is any big trick but the factory manual is so arcane. I stopped reading after the 4th page of describing some crazed, complicated contraption your supposed build to remove the engine.

Again, I only need to lower it a few inches. Any body no a DIY thread or wannna make one make on with som practical directions?

Thanks a lot, P.K