Need to Drop a Boxster motor a few inches Help!
Hello,
How do I temporarily drop my engine a few inches. I’ve got a TPC super charger that’s got one pipe from the “below board” sc up to the top deck. TPC claims 100% bolt in. Everyone I met spent hours trying to fit the pipe in ( I did and gave up). A knowledgeable guy said “just drop the engine a few, no prob”. Makes sense to me, but how? I’ve yanked and dropped lots of engines, can’t imagine this one is any big trick but the factory manual is so arcane. I stopped reading after the 4th page of describing some crazed, complicated contraption your supposed build to remove the engine. Again, I only need to lower it a few inches. Any body no a DIY thread or wannna make one make on with som practical directions? Thanks a lot, P.K |
All times are GMT -8. The time now is 12:39 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website