Parting out a whole lot of Boxsters

[itsnotanova]

Originally Posted by jpc1818

Little bit of a ling shot, looking for a 986 cover and a z-top?
Thanks,

I've never even seen a Z-top in person. I keep my 986 covers. They come in handy on keeping cars protected from the sun and rain.

Originally Posted by Nmbrsix

Woody, I need a complete, intact front belly pan when/if you get another one. Also, do you have the guards that go in front of the front wheels?

I have the belly pan but those front guards are always missing or broke on the cars that come in

Originally Posted by cky3k2

I am looking for a cupholder out of an 03/04 model. Got anything?

I have a 03/04 cup holder but the front face plate is broke.

Originally Posted by Viper10000

Hey Woody,
I'm looking for a sump plate for a 2002 base 2.7L
Part number 996-107-031-58

I sell all my motors complete and don't have something like that. sorry

Originally Posted by Sassmatt72

Hey woody.
Stuff arrived today carpet is great.
But headlight tray is broken, some bits of plastic in the box
Ddddddoooohhhhh.

It happens this time of the year. I'll get another one shipped to you tomorrow. Sorry


I picked up a 99 today with 175K and a blown tiptronic. Nothing special about it and it doesn't have the double bin or wind mesh.

[KevinH1990]

Woody,

I know this is a bit of a long shot, but I was wondering whether you had any of the memory seat parts shown in this picture:


I'm particularly interested in the trunk control/memory unit that fits in the driver's door sill. I'd also need the wiring that runs from the door sill to the control under the driver's seat. I think that I need a unit from a 2000 or earlier car because they have the mechanical trunk releases.

Thanks

Kevin

[itsnotanova]

I believe I have a 98 and 02 986, and a 2000 996 that had the seat memory option. I'll need to check the condition on them though

[KevinH1990]

Thanks - I'm not exactly sure what I need in terms of wiring, but I expect that there is a connector in the driver's door sill and then one that goes to the module under the driver's seat. I think that connector under the seat would fit into the large vertically oriented terminal that is on the right side of the seat module in this picture:

[DarkStar]

Got any 03/04s? Need the center dash frame/trim/vent/cup holder housing.

Sent from my SM-G900V using Tapatalk

[Sassmatt72]

the damn shipping co didn't break this one.
thanks. matt

[jlindsey86]

Happen to have a seal grey trunk lid with hinges?

[itsnotanova]

Originally Posted by Sassmatt72

the damn shipping co didn't break this one.
thanks. matt

That's good to hear. I've been worried about every package going out for the last two weeks.

Originally Posted by jlindsey86

Happen to have a seal grey trunk lid with hinges?

I do for $50, but I don't ship large body parts. Where in Texas are you?

[ckkrause]

Looking for a 986 car cover and stock 986 Boxster or Boxster S muffler...

Thanks for your response!

-Chuck

[Sassmatt72]

Hey Woody,

Seasons greetings.

I'm looking for a set of....

the center radiator mounting brackets (and the assorted clips and screws).

ok if a little bent I can straighten them out.

thx.

[Sassmatt72]

Hi Woody (again),

I forgot to ask if you have any more steering rack line (ends)
Like what you sent to the EV guy....

thx, Matt

[itsnotanova]

Originally Posted by ckkrause

Looking for a 986 car cover and stock 986 Boxster or Boxster S muffler...

Thanks for your response!

-Chuck

Hi Chuck,
I keep all the car covers that come in. They come in handy for protecting interiors in the early stages of disassembly. I have some mufflers, $50 for a base and $100 for a S. I'll gladly ship you one, but living out there in the land of Porsches. You can probably find one cheaper after shipping is included. I'm guessing $75-100 to ship.

Originally Posted by Sassmatt72

Hey Woody,

Seasons greetings.

I'm looking for a set of....

the center radiator mounting brackets (and the assorted clips and screws).

ok if a little bent I can straighten them out.

thx.

Originally Posted by Sassmatt72

Hi Woody (again),

I forgot to ask if you have any more steering rack line (ends)
Like what you sent to the EV guy....

thx, Matt

Hi Matt,
I don't get too many center radiators. I usually get $150 for the radiator and brackets when I do have one. The lines I sent Mahendra were only about 4-5 inches long. Unless the car is up on a lift, it's hard to get more. I've started to take those off when I remove the motor and trans. Good power steering lines are in high demand among the spec guys. I have another set of short lines or you can wait for a set to come up that has damage to them farther down?


I've decided to sell some rear speaker boxes I've been holding onto. One is the four speaker box but the speakers are blown. You basically are getting the kit to convert your rear storage box into a four speaker storage box. $50 shipped. The other is the bose subwoofer speaker box out of a 2003 for $150+shipping. I also have the Bose dash and door speak too.

Here's some updated pics of my inventory. Nothing special but the silver box in the middle only has 59k and the suspension is still complete.



Here's the boxsters that are in the "buzzard yard". Not much left of them

Latest arrival. 99 with lots of miles and a blown tip. The wheels are spoken for and the engine has a sale pending. Sorry, still no wind mesh.


Also have the 987 that's mostly still complete and only has 64k. The shifter is spoken for.

[jlindsey86]

Originally Posted by itsnotanova

That's good to hear. I've been worried about every package going out for the last two weeks.

I do for $50, but I don't ship large body parts. Where in Texas are you?

I am in Greenville, TX. I did a number on my rear trunk lid...

[Sassmatt72]

Woody do you have a set of the fittings for the steering rack?
Short ones ok.
Thx. Matt

[matriss97]

Looking for the just the front calipers

[itsnotanova]

I normally have a guy who buys all of my calipers as soon as I get them in. I think he's slowed down and isn't taking this last set for now. I only sell them as a complete set of 4. $415 shipped to NewYork
Thx Woody
UPDATE!! SALE PENDING ON THE LAST SET

[steved0x]

Originally Posted by itsnotanova

I have the belly pan but those front guards are always missing or broke on the cars that come in...

I had one of the front guards fall off on an autocross when I hit a cone.... I just left it off...

[silver-S]

Woody, happy new year! Maybe you can answer my headlight question:

Are the headlights interchangeable between 986.1 (through 2002) and 986.2 (2003-4) models? If yes, do you have any clean 986.2 lights available?

Thanks!

[itsnotanova]

I only have one left headlight with a burnt inner lens. It's amazing how fast headlights in any condition sell. Headlights and taillights from 97-04 inner change in 30 seconds with no problem.

[silver-S]

Thanks, man! Too bad about the lights, but knowing this gives me lots more options. I appreciate your advice.