|
Good Grief - tough group.
Radium - you got the message - It "could" be practical. I also thought about routing some ducting from the trunk firewall up into the vents with flex hose.... the top side of the engine gets really hot.
Madmods - at this "prototype" stage (no, I'm not producing these), it's framework is made of oak - contoured to reinforce the trunk lid and retain the plywood pan. It can most definately be made waterproof with a thin sheetmetal pan (even modify a deep dish cookie sheet and then route drain lines along the lid itself into drilled holes just past the rubber deck lid gasket into the cavity for the pop up spoiler.
This project was just a challenge waiting for an answer - with lots of possibilities.... paint the grilles to match... leave them in the original silver aluminum... anyway, thought I'd share with y'all.
kj
|
Threaded Mode
