Durametric Diagnostic Question
Guys I need some expert help still. I have tried to figure this out on my own but I am not there yet, and precious posts are.
I had a funny "diesel like" rattle when sitting more than 4 hours. Did some reading and read code with a scanner (misc cyl misfires bank 2) and concluded chain tensioner. Then car cel started flashing and car ran like missing a cylinder or 2. Changed out tensioner, no luck.
Broke down and bought Durametric and I get the codes (see attached) during short test. When I check actual available values, I get no Camshaft Position Bank 2 deviation reading. Nothing at all. I found the tech article on sensors, checked them out and they all apear to be connected just fine..
Yet I get a P1524 (Cam shaft adjusment bank 2 error. I have checked the sensors and assuming I know left and right, the position senors are all connected. What sensor is responsible for dev bank 2 reading?
|