986 Forum - The Community for Porsche Boxster & Cayman Owners

986 Forum - The Community for Porsche Boxster & Cayman Owners (http://986forum.com/forums/index.php)
-   Performance and Technical Chat (http://986forum.com/forums/forumdisplay.php?f=11)
-   -   My 2002 boxster shot gas back. (http://986forum.com/forums/showthread.php?t=7681)

ZZZAJ 10-08-2006 06:37 PM

My 2002 boxster shot gas back.
 
First allow me to say that I hope some body can tell me. I would like to know why my 2002 boxster that I just got last firday will not allow me to pump gas with out it coming back out at me an all over my car. I can put gas in the car if I use a gas can. I was able to get this problem fix.




But I got my car back now when I open the driver side door you know the window should come down just a bit but what it does is go up. When I open the door from the inside of the car, the window comes down then pop right back up. So when I try to shut my door the window hit the top.

zzzaj

01boxster 10-08-2006 08:30 PM

try to shoot it at diff angles....the box was known to have that problem some time..u can put gas in ur tank with a jerry can is because theres no pressure monitor on ur jerry can...but the pump guns do...so they pop back the handle when ur tank is full..that being said..

its just that ur car's tube tot he tank itself it simulating the fullness of the tank and the gas pump thinks it full...try at diff angles that usally helps..

good luck!

MNBoxster 10-09-2006 08:29 AM

Hi,

There's a chronic issue with the fuel filler tubes on some Boxsters. It requires removing the pump/filter (on an '02), level sender and tying the two filler tubes to the rod w/ nylon ties so that it is held out of the way. Pretty easy procedure, but you need to remove the battery and tray to access it. Hope this helps...

Happy Motoring!... Jim'99

RandallNeighbour 10-09-2006 08:44 AM

Jim, you forgot to mention the use of a special tool to get to the fuel sending unit on which those filler tubes reside. Have you tried doing it with something lying around a typical garage, or is that special tool a requirement?

MNBoxster 10-09-2006 11:01 AM

Quote:

Originally Posted by RandallNeighbour
Jim, you forgot to mention the use of a special tool to get to the fuel sending unit on which those filler tubes reside. Have you tried doing it with something lying around a typical garage, or is that special tool a requirement?


Hi,

There is a special tool, but it's not necessary. I helped a friend do it with a punch and ballpeen hammer, using it gently of course...

Happy Motoring!... Jim'99

JackG 10-09-2006 11:47 AM

Quote:

Originally Posted by MNBoxster
Hi,

There is a special tool, but it's not necessary. I helped a friend do it with a punch and ballpeen hammer, using it gently of course...

Happy Motoring!... Jim'99

Best to use non-sparking tools when working with/around gas tanks. Brass, plastic or rubber faced, but never steel to steel.


All times are GMT -8. The time now is 06:26 AM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website