Where to get cat bypass pipes?

[al83s]

****************************************.com
$274 for a set made by Schnell

[Johnny Danger]

Originally Posted by al83s

****************************************.com
$274 for a set made by Schnell

I would double check that price . I think it might be $274.00 each .

[Johnny Danger]

Originally Posted by jojaanbutt

It wouldn't matter if you installed O2 sensors or not. They will just fail after about a month. With or without them, you will get an Engine Light. Not only will you have the light on, the engine will run like crap to the point it will be ruined.

He's right. The 2.5 variant only has one set of cats. Therefore, if you remove them, you'll be catless . This will certainly trigger cel's, and the only way around it, would be to re-map the ecu.

[Lobo1186]

I was under the impression that you can run the sensors open air. You will still get the CEL but it will not run like crap... either way just get a ROW flash, delete the secondary air system and Viola! magic, cat-less with no CEL and no secondary air bullcrap.

or have it remapped like johnny said with some other aftermarket software.

[mikstew]

CELs for emissions don't really matter much.

Also, it is ludicrous to charge 500$ for 3 feet of pipe with incredibly simplistic bends and only one flange. I would never buy them from fabspeed. The actual value of the fabspeed pipes is about 50 dollars, including labor if they are mass produced in China.

[BYprodriver]

Stebro makes these pipes @ $300 & Stebro is in Canada.

[Lobo1186]

I have said the same thing. waste of dough-flow.

it seems to me that if the boxster likes some back pressure then maybe, having some pressure bent 2" pipe wouldnt be that bad. you would lose weight have some back pressure and have some great sounding exhaust. and its cheap.


but i could be looking at this simplistically.

[Johnny Danger]

Originally Posted by mikstew

CELs for emissions don't really matter much.

Also, it is ludicrous to charge 500$ for 3 feet of pipe with incredibly simplistic bends and only one flange. I would never buy them from fabspeed. The actual value of the fabspeed pipes is about 50 dollars, including labor if they are mass produced in China.

I agree. And for $50 they should throw in a Chinese massage as well. Unfortunately, there are very few choices out there - Fab$peed, $chnell and maybe $tebro .

[chaudanova]

I've got a couple sets available for sale. One is a FVD used set, and one is a new fabspeed style set.. PM if interested...