spark plug seizure

[jaykay]

I have not had the car for very long so I could say whether ant-seize was used or not. I personally do use it for every other car I have had. For all I know these plugs are the same ones that came from the factory!!!! I am guessing that the previous owner had let it go as the mileage for that change has still yet to be reached! The service hist shows nothing...

Is there a good procedure on here that will direct me on how to do it? Looks like I will have to know about a central rear jacking point, jack stands/pads etc...or maybe it can be done with one wheel off at a time. It like the wheel would have to come off anyway. I am a bit hesitant if I am going get a seized plug!

thanks for all the feedback

Super easy. Just jack one wheel at a time, do that side's plugs (and check the o-rings and plastic spark plug tubes, and inspect coil packs), then repeat for the other side.

[Adam]

I'm thinking about just loosening the stock plugs then retightening with a torque wrench since I'm only about halfway to 60k miles. The stock plugs still have plenty of life left in them and that would take lesson the likelihood of them seizing in the head.

[Flavor 987S]

Originally Posted by Adam

I'm thinking about just loosening the stock plugs then retightening with a torque wrench since I'm only about halfway to 60k miles. The stock plugs still have plenty of life left in them and that would take lesson the likelihood of them seizing in the head.

If you are going to do all this work, just buy the new set of plugs for $68 and be done with it.

[jmatta]

My car is seven years old with 17k miles; original plugs. Guess I have another job lined up.

Milk of Magnesia...Jake, you pulling my leg?

Or is that to settle my stomach after I break several coil packs?

If you're going to bother loosening the plugs, you may as well just replace them.

[Jake Raby]

MOM is the best anti-seize that I have ever experienced.. It doesn't effect spark plug grounding while protecting the plug from seizure.

I learned this trick as a Marine working with Gas Turbine engines.. MOM is the only thing we were allowed to use on the ignitor plugs that screwed into a 55,000 buck combustor.

Nothing on your M96 gets as hot as the coolest portion of a gas turbine combustor... We actually had directives that called for MOM.

I have also used tooth paste, dental floss, playdough and Ajax/ Comet in the creation of engines over time :-)

[Sputter]

The first thing I did when I bought my 02s 3 years ago (37k at the time) was to do the 60k maint . It gave me a better idea of the condition of the engine..plug colour etc.

Jim


\

Originally Posted by Adam

I'm thinking about just loosening the stock plugs then retightening with a torque wrench since I'm only about halfway to 60k miles. The stock plugs still have plenty of life left in them and that would take lesson the likelihood of them seizing in the head.

[jaykay]

MOM form the drug store? Spounds funny but when you think of the composition it makes perfect sense.

I ususally tighten to load up the gasket and then loosen and then final torque plugs....any weirdness on the M96?

Can anyone recomend jack stand placement and a proper pad for one rear corner at at time to get at the plugs? Or do I need to use a centre jack point somewhere and then place the stand and pad under the rear rocker jack point and let the car down on one jack stand/pad.....two sound better to me.

....i need a real garage