![]() |
headlamp stalk fault
My headlamp stalk will not operate dipped or main beam without holding it back.
Headlamps do not work at all dipped. I have a 2004 S Tiptronic without cruise....ie. 3 stalks. Pelican have a switch stalk with 3 arms for $444! Can't believe a small switch can be that expensive.. Anybody done a repair??????http://986forum.com/forums/uploads01...1446048584.jpg |
Contact Woody "itsnotanova" for the part. I just sold a 3 stalk for $45 shipped on eBay.
Better yet, upgrade to a 4 stalk and enable your onboard computer! They should not be expensive. |
I bought a 3 stalk from Gaudin Porsche (on line) in Feb 2012 for $177.91, shipping included. Google them. I'm in NC, they are in Nevada.
I replaced it myself, and it wasn't bad. My only mistake was I reconnected the battery terminal before reconnecting everything, and I ended up with a check engine light that I had to get reset. I followed this you-tube tutorial: https://www.youtube.com/watch?v=hux78ZoPcAI It was almost four years ago, but from what I remember it wasn't a hard project. I wish I had done the four stalk and enabled the OBC. |
thanks for that
Got headlamp and computer on the left and washer/wipers on the right but no cruise hence 3 stalk will try 'woody' can I google it? John. |
Quote:
Issue sounds more like symptoms of a bad headlight switch... not stalk. Doubly so w/ litronic lights. If so, repair part (though not inexpensive) should be less than half the cost of a new stalk... and much simpler to DIY. If you have the wiring diagram you can remove the existing switch and make a jumper to test the lights. Good luck :) |
Quote:
His user name on the boards is "itsnotanova" and this is the thread that has all of his part out cars. http://986forum.com/forums/boxster-parts-sale-wanted/52469-parting-out-whole-lot-boxsters.html He may have the one you are looking for. I do know that there is a way to enable cruise control on a boxster so a 4 stalk may also work. Here is the procedure on the Pelican Parts site Porsche Boxster Cruise Control Installation - 986 / 987 (1997-08) - Pelican Parts Technical Article Good luck! John |
I have a 4 stalk that I removed the OBC levers on. You could reuse your existing OBC lever on this one.
I will let it go cheap. Let me know if you want it. |
Probably not the stalk. Likely that your headlight switch is bad. ;)
|
All times are GMT -8. The time now is 06:17 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website