Ignition Switch Question not returning from Start to ON

[professorman]

Ignition Switch: The key is not always springing back fully from the START position to ON. When it doesn’t return all the way, my wipers won’t work until I manually click the key back a little.

The key action also feels slightly stiff.

I recently replaced the ignition switch with the URO white switch.
- Has anyone experienced this with the URO switch?
- Is there anything in the key cylinder or mechanism that can be lubricated safely?
- Could the electrical switch install be slightly misaligned?

[KevinH1990]

I installed a URO ignition switch that failed after about a month. I replaced it with another URO switch and that one has been fine for several years. I have seen several threads that suggest URO's quality control may not be at the same level as some other brands.

Given the symptoms you described and my experience, I think it's possible that you installed a defective part.

Good luck.

[professorman]

Thanks. I have cleaned my outer Ignition switch and hoping for the best now. Will report back if it solved it or not.

https://youtu.be/ixmVADj_Czo

[DonQ]

I’m not a fan of URO parts.
I bought a replacement corner headlamp lens for my drivers side headlamp with the washer nozzle. It wouldn’t even fit. I had to use an exacto knife to do some surgery on it and finally got it to click on. When I installed the headlamp it cracked.
Bought a genuine Porsche item and it clicked on easily and has been fine. The URO didn’t sit flush either, looked bad.

I should have spent the extra 20$ and saved the hassle and the money spent on an inferior part. I think a used genuine part would better than a new URO item.

[Coaster]

I had the exact same URO corner light issue. Used a razor to shave it down and it still doesn't sit flush.