|
Ok so here's some data. The Durametric didn't have any Post Cat tests that I could find.
The numbers are hard to read here so they are as follows.
Test1 .44 both banks
Test2 1.8 Ohms didn't have a voltage readout
Test3 .98 at idle both banks (durametric only specifies oxygen sensors cyl 1-3 and cyl 4-6 don't know if its pre or post))
Test3a (Same as 3 but at a different time) seemed somewhat erratic but what do I know.
Somehow my CEL cleared itself while testing. It was not reset cause all my readiness tests all passed when I checked ie. heater/cats/secondary air etc...
sent a PM as well ....I have a video using my torque light on my droid if you're interested. Thanks Again....V
Last edited by Vza; 07-27-2021 at 08:30 PM.
|
Threaded Mode
