|
No, sorry. I replaced the springs on both sides. Bilstein HD's were not changed. It was the rubber ring that goes around the edge of the strut mount where it creates a cushion between the mount and body. I only replaced left side. Dumb I know. It looked a bit rough.
Can I tighten the strut mount with the strut disconnect from the body but still in the wheel well? I had a tough time since I couldn't use my torque wrench since I had to put an Allen wrench (or something similar) on the strut shaft to keep from turning. So maybe it just needs to be tightened a bit.
Sorry, mechanics is not my first language.
|
Threaded Mode
