08-12-2010, 05:20 AM
|
#1
|
Registered User
Join Date: Dec 2008
Location: New York
Posts: 116
|
Quote:
Originally Posted by Peer
Oh, by the way, I had the car smog checked (CA) after this episode, and it passed with flying colors.
-- peer
|
I was going to suggest that you get your car inspected while it is not throwing codes, so then you don't have to worry about the CEL for a whole inspection period. But it sounds like you might have done that by getting the CA smog test. Here in NY the emissions test is part of the NYS inspection process. I'm guessing CA is more stringent [CA people often complain about it  ].
My CEL was off for about 9 months, I kept putting off the inspection. Now I have 1 month left, and my CEL came on yesterday ... :ah:
|
|
|
08-12-2010, 08:42 PM
|
#2
|
Registered User
Join Date: Apr 2009
Location: Perth, Australia
Posts: 165
|
Bladecutter is 100% correct. Get the code read and go from there.
I made that mistake when I had an intermittent CEL. I found that if I started the car from cold and drove it hard straight away there was no CEL. If I drove it gently until it warmed up, CEL would come on without fail. I took some advice (bad advice I might add) from someone who (mis)diagnosed it as a failing MAF sensor. The advice was unplug the sensor, and if the CEL goes out then it is the problem. I did this, the CEL went away (although the car was way down on power) so I assumed it was the problem. I bought a new MAF sensor, installed it, and the CEL came straight back on!
As it turned out, the problem was O2 sensors, and the CEL didn't come on whilst the MAF sensor was unplugged just because it wasn't getting an important reading. Once the O2 sensors were replaced it was like new again.
Moral of the story, get the codes read and forget guesswork. It could be a frustrating and expensive exercise otherwise.
Good luck!
|
|
|
08-13-2010, 03:49 AM
|
#3
|
Registered User
Join Date: Mar 2007
Location: Ohio
Posts: 2,027
|
Quote:
Originally Posted by Daniel R
Bladecutter is 100% correct. Get the code read and go from there.
I made that mistake when I had an intermittent CEL. I found that if I started the car from cold and drove it hard straight away there was no CEL. If I drove it gently until it warmed up, CEL would come on without fail. I took some advice (bad advice I might add) from someone who (mis)diagnosed it as a failing MAF sensor. The advice was unplug the sensor, and if the CEL goes out then it is the problem. I did this, the CEL went away (although the car was way down on power) so I assumed it was the problem. I bought a new MAF sensor, installed it, and the CEL came straight back on!
As it turned out, the problem was O2 sensors, and the CEL didn't come on whilst the MAF sensor was unplugged just because it wasn't getting an important reading. Once the O2 sensors were replaced it was like new again.
Moral of the story, get the codes read and forget guesswork. It could be a frustrating and expensive exercise otherwise.
Good luck!
|
A related question, out of curiosity. Was it just one O2 sensor you got the code for, or more than one? How many did you replace---just the one(s) throwing the code(s) or all of them? I ask, because I'm currently in a similar situation.
|
|
|
08-13-2010, 02:17 PM
|
#4
|
Registered User
Join Date: Jan 2009
Location: Arvada, CO
Posts: 229
|
Quote:
Originally Posted by Frodo
A related question, out of curiosity. Was it just one O2 sensor you got the code for, or more than one? How many did you replace---just the one(s) throwing the code(s) or all of them? I ask, because I'm currently in a similar situation.
|
Its always better to replace them all as a set, because they get contaminated with exhaust stream during usage, and over time, they degrade in performance.
Replacing just one or two might clear the CEL, but the chances of it coming back on soon are much higher, when the computer realizes that the unchanged ones are slower to respond than the new ones.
Think of it this way:
If the Original 4 O2 sensors lasted 12 years, and 100k miles, would you rather replace all 4 at the same time, and not need to change them again until the 200k mile mark, or would you rather have to keep inspecting the CEL every 25k miles, until all 4 are replaced at 200k miles, when you might then have to replace the first one again, etc...
BC.
__________________
Its not how fast you go, or how expensive your toys are.
Its all about how big your smile is at the end of the day that truly matters.
'98 Silver Boxster, '08 Ducati 848, '89 Honda Hawk GT, '89 Honda Pacific Coast
|
|
|
08-13-2010, 02:37 PM
|
#5
|
Registered User
Join Date: Mar 2007
Location: Ohio
Posts: 2,027
|
Except mine (the post-cat ones) are cutting out at 9 years and 53K miles
But I get what you're sayin'.
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is On
|
|
|
All times are GMT -8. The time now is 03:32 PM.
| |