clutch pedal problems help plz

[dirtyg]

i tried that using the bleeder i have and the pedal slams to the floor now instead of not activating the cluch witch is what it was doing when i pet it home the other night

[dirtyg]

ih all i intend on changing the master and slave cylinders and want to know if i have to change a section of line and must also get a new union

[dirtyg]

any elp would be appreciated

[Mark_T]

I just replaced a section of the clutch pipeline (second section from the front). The part came with a union and circlip screwed on to the tail end of the line. I'm pretty new to this DIY business, so that threw me for a bit until I realized that the supplied union is actually for the front end of the line because the old union is not removable from the old line.

I'm not going to write several more paragraphs on how to do this unless you actually want the advice, but feel free to ask any questions you may have. I've had to spend quite a bit of time over the last couple of weeks figuring this out. Once you've done it once it seems incredibly simple, but if, like I was, you are starting from the point of zero knowledge, it can be a bit of a head-scratcher.

It also seems to be an area where there is little collective knowledge available from the group as my pleas for help went, for the most part, unanswered. (That is absolutley not a complaint, btw, just an observation.)

Good luck!
Mark

[dirtyg]

well im trying to figure out if to change the master cylinder or the slave if changing lines are nessacary since pelican parts is telling me i need a line and a union as well as the cylinders just dont want to get something i wont need

[Mark_T]

If that's the section that couples the clutch pipeline with the slave cylinder then, I'm told, if it is not sweating, bulged, or otherwise damaged you can re-use it and just replace the slave cylinder. Buying that extra union doubles the cost of the job.