Kicker KX150.4 2-4 Channel Amplifier

[particlewave]

SOLD! Thanks!

Hardly used Kicker KX150.4 2, 3, or 4 channel amp. Clean sound, bridgeable.

@ 14.4V, 4Ω Stereo - 35 x 4

@ 14.4V, 2Ω Stereo - 45 x 4

@ 14.4V, 4Ω Mono - 90 x 2

Built in High/Low pass crossovers, bass and level gain. Pretty standard stuff.

Height: 2.5 inches / 6.35 centimeters
Width: 10.125 inches / 25.7 centimeters

Frequency Response: 20 Hz - 20 KHz, + 0, -1dB
Input Sensitivity: 170 mV - 5 V low level, 340 mV - 10 V high level
Signal-to-Noise Ratio: >95 dB, a-weighted, re: rated power
Electronic Crossover: Fixed high or low pass at 80Hz, 12 dB/octave
KickB Bass Boost: :Variable 0 to +12 dB boost @ 40 Hz


$60 shipped OBO.

[emore93]

PM sent....

[particlewave]

Sale pending.

[epapp]

Why you no use it?

[particlewave]

I bought it new with my Kicker sub about 3 years ago on a splurge, planning to run 1 bridged mono channel to the sub and the other 2 to power a rear shelf dual sub setup, but never got around to getting the rear shelf subs because the one 8" kicker was plenty.

I used it for a while in my DD, but have since went back to stock since the car was broken into and aftermarket HU stolen.
It was in the car for maybe a month.

[epapp]

Aw man, thats horrible.

Thread spoiled, but, where did you put the sub? I too have a square kicker 8" with a single channel 600W alpine amp that I used in a previous car. The enclosure makes it hard to properly position anywhere in the car so I've left it out for two years.