Quote:
Originally Posted by Starter986
Google revealed it in .0087656 seconds. 
|
Thanks, guys, for the reply. And I can now see what happened.
Before I posted the pictures, I too did a web search on the part number via my (non-Google) search engine. The difference was that I broke the 9 digit part number into 3 groups of 3 digits, separated by the pair of periods, exactly as shown on the part and on the paper as you can see. This search came back empty. But then, based on your reply, I went back and repeated the search using this same search engine, now as a single 9 digit number w/o periods. And yup, lots of hits! So, Lesson Learned, with my thanks to you all for the insight.
In any case, the various parts diagrams which are contained on some of these pages clearly show a pair of these parts are to be used. But in my case, there wasn't one on my passenger's side - thus my question.
The shape of the parts makes me think that they might be intended to be inserted as a bushing/spacer after the fact on an as-needed basis? If not, why not just make it in a conventional simple round washer configuration?
I'll be ordering a pair today, and I will install them as the final step, when and if I end up seeing a gap which they need to fill.
Again, thanks - DM