View Single Post
Old 11-06-2018, 02:22 PM   #19
BYprodriver
Registered User
 
BYprodriver's Avatar
 
Join Date: Oct 2008
Location: O.C. CA
Posts: 3,709
Garage
Quote:
Originally Posted by BOOTLEG View Post
thx for this pic. I have a pair of these jack stands and preparing to raise my 986S for an engine swap. This pic answers my question of how high? Guess I don't need the 2X12 I was thinking about placing beneath the ESCOs. What kind if cart (height) did you use to roll it away?
Thx!
I used a 500lb capacity "lift table" I got from Harbor Freight which would lower to about 10" above the floor so I had to remove muffler & rear bumper etc.
__________________
OE engine rebuilt,3.6 litre LN Engineering billet sleeves,triple row IMSB,LN rods. Deep sump oil pan with DT40 oil.
BYprodriver is offline   Reply With Quote