View Single Post
Old 08-26-2017, 04:49 PM   #13
Gelbster
Registered User
 
Join Date: May 2014
Location: S.California
Posts: 2,027
Try a straightedge across the face of adjacent pullies -as many as you can span. I was surprised that the A/C pulley was significantly out of line with the rest of the pullies. This tended to put a lot of distorting force on the adjacent pullies.
If you replaced just the bearings in any pulley - you may not have seated the bearing fully or you cracked it on the press. Better to use a new combo pulley+bearing in my limited experience.
Gelbster is offline   Reply With Quote