View Single Post
Old 04-13-2016, 10:16 AM   #7
steved0x
Registered User
 
steved0x's Avatar
 
Join Date: Dec 2012
Location: FL
Posts: 4,143
I have the kit and have done the rear and am about to do the front.

Pelican shows it wrong on their website in Figure 16, when pulling the hub there is no backing plate used, just the big 27mm nut that is used to counterhold the back when you are turning the 24mm nut on the front side. I made that same mistake and twisted the end off my 3/8" breaker bar. Luckily the tool is much stronger than a harbor freight bar...
steved0x is offline   Reply With Quote