Thread: winter project
View Single Post
Old 11-20-2012, 12:20 PM   #16
Meir
1999 base
 
Meir's Avatar
 
Join Date: Dec 2011
Location: Coral Springs FL
Posts: 1,617
Garage
Quote:
Originally Posted by Kenny Boxster View Post
Hi Meir,

Any engine support bar should be fine, as a lot of forum members have used them in the past. My understanding is that the Boxster engine weights around 400-500 pounds so the support bar should be more than adequate. When I took out my transmission, the car was on jack stands, so I just used a jack like Wayne. An engine support bar would be a good idea.
thanks Kenny.
just wasn't sure if this thing will fit on the sides rails.
worst case i will adapt it.

working with this support will help me a lot. it will allow me to rise and lower the car during the process, to get access to some top bolts, and also use a low profile transmission jack.
Meir is offline   Reply With Quote