Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Search Forums

Showing results 1 to 6 of 6
Search took 0.01 seconds.
Search: Posts Made By: insite
Forum: Boxster General Discussions 03-02-2011, 05:16 PM
Replies: 35
Views: 6,349
Posted By insite
Sparked - I checked; the fitting is...

Sparked -

I checked; the fitting is removable. It takes a 28mm wrench.
Forum: Boxster General Discussions 02-03-2011, 03:37 AM
Replies: 35
Views: 6,349
Posted By insite
use two wrenches. there's a plastic cover under...

use two wrenches. there's a plastic cover under the car just in front of the left rear wheel. remove the cover to expose the fittings. prepare to catch a little pentosin when you break the line.
Forum: Boxster General Discussions 02-03-2011, 03:25 AM
Replies: 35
Views: 6,349
Posted By insite
as you pull on the tube, the red piece will try...

as you pull on the tube, the red piece will try to come with it. press it back into the reservoir & keep pulling.
Forum: Boxster General Discussions 02-03-2011, 03:16 AM
Replies: 35
Views: 6,349
Posted By insite
it will probably be pretty tough with the intake...

it will probably be pretty tough with the intake & ac compressor in place. the idea is to pull the tube out of this hole while pressing the red thing back into the reservoir:
...
Forum: Boxster General Discussions 01-27-2011, 03:47 AM
Replies: 35
Views: 6,349
Posted By insite
that line goes from the pump down to a fitting...

that line goes from the pump down to a fitting underneath the car. since you were quick to turn the car off & the fire sounds like it went out, you may not be too bad off....

you'll need to...
Forum: Boxster General Discussions 01-27-2011, 03:33 AM
Replies: 35
Views: 6,349
Posted By insite
there is a power steering line that runs very...

there is a power steering line that runs very close to where aftermarket headers tend to route. it's on the left side of the car near the rear wheel. my guess is that your header melted the PS line...
Showing results 1 to 6 of 6

 
Forum Jump


All times are GMT -8. The time now is 03:55 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page