Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Search Forums

Showing results 1 to 14 of 14
Search took 0.01 seconds.
Search: Posts Made By: gaseavey
Forum: Boxster General Discussions 08-17-2012, 04:44 AM
Replies: 4
Views: 1,080
Posted By gaseavey
I recently experienced the same. Both lights...

I recently experienced the same. Both lights would come on and stay on. Shut the car down restart lights off, then after driving a few minutes both lights on again.

The solution that fixed the...
Forum: Boxster General Discussions 02-26-2009, 10:07 AM
Replies: 19
Views: 2,072
Posted By gaseavey
Very Nice Photo. It appears to be an HDR?

Very Nice Photo.
It appears to be an HDR?
Forum: Boxster General Discussions 01-19-2009, 05:30 AM
Replies: 3
Views: 1,115
Posted By gaseavey
I also have a 2002 and if you open the passenger...

I also have a 2002 and if you open the passenger door near the upper door hinge you should see the release wire. Good Luck
Forum: Boxster General Discussions 10-09-2008, 05:58 AM
Replies: 31
Views: 4,273
Posted By gaseavey
mts; Thanks for the input. By the way...

mts;

Thanks for the input.

By the way you have a fantastic garage, maybe some day.

Picture of mine testing for winter storage.
Forum: Performance and Technical Chat 10-03-2008, 09:13 AM
Replies: 8
Views: 1,801
Posted By gaseavey
That is similar to what I am planning on doing. ...

That is similar to what I am planning on doing.

Thanks
Forum: Boxster General Discussions 10-02-2008, 12:04 PM
Replies: 31
Views: 4,273
Posted By gaseavey
I have often wondered how the epoxy painted floor...

I have often wondered how the epoxy painted floor would be.
Is it to slippery?

A picture of my garage below.
Forum: Performance and Technical Chat 10-02-2008, 07:27 AM
Replies: 8
Views: 1,801
Posted By gaseavey
I want to thank you all for your inputs and...

I want to thank you all for your inputs and suggestions.

I do not have a specific problem I am just trying to learn as much as I can about the car.

A number of years ago I owned a 912 that I...
Forum: Performance and Technical Chat 09-30-2008, 02:19 AM
Replies: 8
Views: 1,801
Posted By gaseavey
My limited experience with the dealer ( one...

My limited experience with the dealer ( one visit) says that they probably will not be helpful.
I have searched a lot on this forum and Renntech and found bits and pieces but not a comprehensive...
Forum: Performance and Technical Chat 09-28-2008, 10:37 AM
Replies: 8
Views: 1,801
Posted By gaseavey
Actual Values Durametric

I am wondering if there exists a comprehensive list of the acceptable range for the actual values that the durametric would measure for a '02 base Boxster.
Forum: Boxster General Discussions 08-28-2008, 01:33 PM
Replies: 14
Views: 1,420
Posted By gaseavey
Bob O Being a new owner of a Porsche Boxster...

Bob O

Being a new owner of a Porsche Boxster and after reading the many forum discussions about this subject I decided to be concervative and mask the car.

That said I did notice that even...
Forum: Boxster General Discussions 08-28-2008, 11:13 AM
Replies: 14
Views: 1,420
Posted By gaseavey
I believe my issue is resolved. I went for a...

I believe my issue is resolved.

I went for a short ride and the light gray particles are now gone, presumably blown off.

Also now the top is darker then before the treatment which I had...
Forum: Boxster General Discussions 08-28-2008, 09:48 AM
Replies: 14
Views: 1,420
Posted By gaseavey
I sprayed from about 20 inches from the surface. ...

I sprayed from about 20 inches from the surface.

I did the job in my garage with the car masked off.

What I see are not drops they look like small gray highlights as if they are a powder.

It...
Forum: Boxster General Discussions 08-28-2008, 09:03 AM
Replies: 14
Views: 1,420
Posted By gaseavey
thanks Kirk I could not tell if it wasn't...

thanks Kirk

I could not tell if it wasn't dry or if it was just particles that were extra on the surface. I will give more time before I touch it to see what happens.

Gary
Forum: Boxster General Discussions 08-28-2008, 08:26 AM
Replies: 14
Views: 1,420
Posted By gaseavey
Just treated Soft Top with RaggTTop

I have just treated my softtop with Raggttop and have a question.

After applying the protectant to the surface of the black softtop it has a look of small lighter particles on the surface. Will...
Showing results 1 to 14 of 14

 
Forum Jump


All times are GMT -8. The time now is 11:24 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page