Removing Stock Exhaust...

[Cloudsurfer]

So I pulled off the stock exhaust on my 02 S today for a GHL. GHL was a breeze to install. Getting the stock exhaust off, not so much. Since the exhaust is part of the crash structure Porsche engineered, its in there VERY well. Were I to do this again, I would absolutely remove the rear bumper to do this. Getting the upper bolts out is a ridiculous chore. I'd say if your shop will do this for an hour's labor I'd have it done. Swapping various aftermarket systems seems very easy, but getting the stock out is a royal PITA

Just thought I'd share.....

Patrick

[Bavarian Motorist]

Yikes. How long did it take you to get it off and how long did the install take?

[Boxtaboy]

Took me and a buddy 1 1/2 hours to swap out my stock exhaust for the dansk, and that includes taking off the rear bumper, spoiler and some heat shields to do it. It's easier to take the exhaust off this way as it gives you much more room to do your work, but then again, you have to take off all these other parts and then also put them back.

[Ghostrider 310]

It's not a tough job, especially once you know the clamps are splined, on a lift the top bots are easy too.

[Cloudsurfer]

As I said in my previous post, you really HAVE to take off the rear bumper. I managed to do it without, but it was very much not a fun project. When I asked my local dealer after the fact and they said they would only charge and hour labor for it....I was a lil upset lol.

The way I see it, if your dealer will do it for $75 I'd just let them do it. If you have a lift and can remove the rear bumper, not a bad job. Laying on your back under the car without the rear bumper on I cant recommend....

Patrick

[trimer]

Originally Posted by Boxtaboy

Took me and a buddy 1 1/2 hours to swap out my stock exhaust for the dansk, and that includes taking off the rear bumper, spoiler and some heat shields to do it. It's easier to take the exhaust off this way as it gives you much more room to do your work, but then again, you have to take off all these other parts and then also put them back.

Was there any issue taking out all the heat shield and the steel brace on the rear?

[jb92563]

I recently removed my stock exhaust as well up to the headers and It was not difficult, but it did take a bit of trial and error finding the muffler nuts with the socket wrench by feel alone. But not hard to remove once your on it.

Took about 3 hours to remove and install mufler and 2nd cat delete pipes.

I jacked up the rear only on jackstands as it produces the perfect angle for getting at everything.

No splined bolts to contend with either and I gave everything a good soaking with wd40 before getting started and had no nut/bolt issues.

[pjq]

2004 S
When I did my exhaust, the original bolts and nuts were suppose to be a 13mm but they must have rusted enough that I had much better luck with 1/2 inch wrench especially on the manifold bolts.