Clutch what did I do
I just replace my clutch and axles. bled the slave cylinder for and hour I can't get the pedal to pop back out the whole way. Pull the transmission again to make sure I didnt pop the arm off the pivot or disconnect something. Put it all back together again and I still have to pop the pedal up. New Spec 1 clutch and pressure plate replaced an old Spec clutch.
|
I had the exact same symptoms. Replaced the slave thinking that was the problem but it turned out to be a cracked (plastic) clutch line that was leaking behind my fender. There’s an an upgraded version, IIRC.
More here: https://www.renntech.org/forums/topic/38449-small-puncture-in-clutch-line/ |
Is it just a fraction of an inch or is it a lot more? Your clutch assist spring may be broken if its just a little bit.
|
Quote:
|
I agree, Your clutch assist spring may be broken, an easy ckeck above the pedal.
|
Quote:
My indie rebled the clutch line and all was good. |
If it ends up being the spring, I have a bunch of extra McMaster “upgraded” springs & can send you one for the cost of postage.
|
OK I changed the brake pads and flushed the lines another time problem resolved. Thanks everyone for your replies, I should have done this first.
|
All times are GMT -8. The time now is 08:19 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website