Steel IMSB
If you have installed a replacement steel IMSB, which one did you install? Why?
If you are planning a new steel bearing installation, which one have you chosen? Why? Thank you. A.C.T. |
I replaced the stock NSK with a Nachi bearing with full Viton seals and high temp grease. I chose this because the Viton in the Nachi is a superior material at temperature and I wanted a higher temperature bearing. Choosing a fully sealed bearing was also important to keep the oil and grease separate. The caveat is I also modified my IMS shaft to eliminate the pressure differential in the IMS that will push oil through the bearing seals.
|
James,
Thank you for the reply. I appreciate your willingness to help. I have read several of your related posts with interest. Best regards, A.C.T. |
All times are GMT -8. The time now is 11:22 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website