986 Forum - The Community for Porsche Boxster & Cayman Owners

986 Forum - The Community for Porsche Boxster & Cayman Owners (http://986forum.com/forums/)
-   Performance and Technical Chat (http://986forum.com/forums/performance-technical-chat/)
-   -   yet another window problem (http://986forum.com/forums/performance-technical-chat/49487-yet-another-window-problem.html)

linderpat 11-16-2013 04:57 PM

yet another window problem
 
did a search and read the good sources from the window thread, but I haven't seen this one discussed. Driver's door - just started today - when I open or close the door, the window goes down as it should, but then immediately goes back up, causing the glass to be outside of the roof channel when the door is closed again. I am afraid I'm going to break the glass. Getting in, all I have to do is lower it a bit and then manually raise it, and it goes back up into the proper place in the window channel in the roof. When I get out and park, I can't do anything except try to close the door real fast.
I tried resetting it per the manual and the advice here, but no luck. Is it a microswitch? Is failure sudden? I had the roof open in the service position today for a bunch of engine maintanence - could that have affected anything?
Thanks in advance.

thom4782 11-16-2013 05:24 PM

Don't know for sure, but I'll take a guess: a sensor in the driver's door thinks it's closed and the window should be raised fully even though the door is open. Hence the window goes back up. I'll bet this happens as soon as you release the inner or outer door handle.

linderpat 11-16-2013 07:15 PM

Quote:

Originally Posted by thom4782 (Post 372606)
Don't know for sure, but I'll take a guess: a sensor in the driver's door thinks it's closed and the window should be raised fully even though the door is open. Hence the window goes back up. I'll bet this happens as soon as you release the inner or outer door handle.

yes, that is what is happening. So you think it is one of those microswitches?

thom4782 11-16-2013 07:30 PM

Yes, there is a specific microswitch that tells the car whether the door is open or closed. I believe it's part of the door lock assembly. Someone else can confirm, but I think the fix is to replace the assembly.

linderpat 11-17-2013 03:42 AM

which microswitch is it? I believe there are 7 of them in the door. My inclination will be to try to fix it myself first.

thom4782 11-17-2013 05:20 AM

Look at these two links. I think the switch in on the top of the lock mechanism. It's under the cam that rolls when the door handle is lifted.

Which Micro Switch - 997-1 Series Part Number Requests - RennTech.org Forums

Door In White Installation Parts Door Lock

linderpat 11-17-2013 02:11 PM

thanks Thom - the renntech thread is my problem exactly. I will take the door apart and see if there is something I can fix.

ilikeching 11-18-2013 02:36 AM

I had the same issue, changed all the microswitches(doorhandle, new doorlock),
it did not help, but i finally found my problem,
it was cracked door wires.
I think when window going up/down,
it scrubs the wires(maybe not proberly installed) over long period...
So check the wires too.

http://986forum.com/forums/uploads01...1384774396.jpg


All times are GMT -8. The time now is 07:38 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website