Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Performance and Technical Chat

Post Reply
 
LinkBack Thread Tools Display Modes
Old 09-21-2012, 04:59 AM   #1
Registered User
 
dagdisco03's Avatar
 
Join Date: Jul 2012
Location: CT, USA
Posts: 104
Garage
If you are talking about the axle stub spindle where your half-shaft bolts to yes there are bearings and they can be replaced. I think it's possible to do it in the car but I would pull the gearbox to make it A LOT EASIER. Then I'd check or replace IMS bearing and clutch to make sure that's not the area of concern. You can pull the gearbox with the car on jack stands. One of my older posts shows my car on jack stands with the gearbox removed. It's not that hard but I don't advise this if you have never done this type of work on a cheap car that won't cost you big if you mess up.
__________________
2000 Boxster S
dagdisco03 is offline   Reply With Quote
Post Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 05:31 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page