Using Durametric to Detect IMS Bearing Weakness

[Jaxonalden]

Thanks Jager, I'm going to do a quick check with my laptop and see where my deviation is. Praying for a 0.0.:dance:

[ChairmanRon]

Thanks -- I'm going to run that test when I get back home in a few days. And I'll flip if it's near there.

Next time I buy a Boxster I'm bringing my laptop and Durametric cable for the test drive!

[jaykay]

Are these cam shaft parameters easily read from all OBD port scanners....can I get it on my iPhone?

I dont know too much about durametric software and the required hardware. What are all the uses and are there any alternatives? What is the cost and where can one buy the equipment?

[ChairmanRon]

Originally Posted by jaykay

Are these cam shaft parameters easily read from all OBD port scanners....can I get it on my iPhone?

I dont know too much about durametric software and the required hardware. What are all the uses and are there any alternatives? What is the cost and where can one buy the equipment?

I've only had the chance to use my new Durametric cable/software a few times, but as both a tech guy and a Porsche guy I'm thrilled with it. Knowledge is power, and with the Durametric you can see everything the car's multiple computers see. Far more powerful than a mere code reader. Check out their videos, which provide a pretty good explanation of what it is capable of.

For $300, it is the best money you can spend on your Porsche.