Fuse ?

[Johnny Danger]

Does anyone know which fuse (if any) corresponds with the MAF sensor ?

[jaykay]

Try checking C1 engine electronics in the footwell....first other than that not too sure!!!

[Johnny Danger]

Apparently there isn't a fuse for the MAF sensor .

[Jager]

Why were you looking... Do you have an issue?

[Johnny Danger]

Originally Posted by Jager

Why were you looking... Do you have an issue?

I have a cel that's coming up as code P0102 which pertains to a low voltage reading associated the maf sensor . This can involve a faulty wire or ground problem somewhere between the sensor and the DME . On the other hand, it could just be a bad sensor . However, it's important to first rule out a bad connection . On a hunch, I thought that I would consider the possibility of a blown fuse . Oh, well .

[Jager]

How's the car's performance... Is there any noticeable change?

Jager

[Johnny Danger]

Originally Posted by Jager

How's the car's performance... Is there any noticeable change?

Jager

Let's see, rough idle, occasional power surge at high rpm's, a backfire once or twice, those kinds of things .

[Jager]

Well... The occasional power surge at high RPM's is good.

[Steve Tinker]

Disconnect the MAF and run the car - if there is a noticible difference in the problem, you have the culprit.