|
This is what I would do. The shaft that the linkage is connected to, there is a set screw that connects them. Pull the set screw and look through the hole it was in. Make sure that it is aligned and put the set screw back in and make it nice and tight. Also check that the cables are still in there retainers a little further up on the transmission. May also need to bleed the clutch or may even need a clutch. I hope this helps. You may know all this already but this is just my thoughts on it.
__________________
996 3.4 engine with 2.7 986 5speed transmission
Ebay Headers, Fabspeed high flow cats, JIC Cross, IPD Plenum, H&R Coilovers, B&M Short Shifter, AEM Uego Gauge Type Analog, Apexi S-AFC Select, 987 air box, Litronics, 2000 Tails and side markers, painted center console, 18" 987 S-Wheels, GT3 Front bumper with splitter.
|
Threaded Mode
