I am not really sure how long the leads should be, but my guess would be roughly the same length. the distance the wires should travel looks like it would be about the same, perhaps add 6 inches or so for safety sake. just guessing here

Question for the Non 4 Stalk
 

Will a regular push on terminal fit the porsche dash switch you are going to be using...I am ready to start making up cables..all my stuff finally came in.

Another question
 

If you are using the ondash switch instead of the 4 stalk do you only need 2 wires and a ground ?

If so I can do the cable for a better price

the switch I am planning on using is just a window switch. so two leads and a ground should be fine, because the illumination of the switch will not be used (it would be too confusing for people to see the window diagrams on the dash).

Hi all,

beacause my car has the board computer i took some photos, so you can see what the cable will add.

Exterior temperature:
http://986forum.com/forums/uploads01...1405435361.jpg

Average speed:
http://986forum.com/forums/uploads01...1405435346.jpg

Average fuel consumption:
http://986forum.com/forums/uploads01...1405435378.jpg

Remaining range:
http://986forum.com/forums/uploads01...1405435389.jpg

Regards from germany
Markus

Get it while it's hot!
Porsche 911 996 986 Boxster Signal Wiper Cruise Computer Switch 99661321900 | eBay

Whata deal
 

It even has the arm "washer" that you have to order that is like a 18 dollar part for a piece of rubber.