Changing the color of the Climate Control and switch back-lights

[Ghostrider 310]

Pwave, It looks so much better than stock it's dramatic! As for your comments on soldering, I've had to do it on a few boards before with only about a 50% success rate. Your caution should be well heeded, it's not like joining two wires. If you overheat it and some other solder on the board runs, that is truly where the new cusswords are created.

[Iflylow]

pwave, That dash looks awesome.

I would ask you to make one, but I've found that half the fun of the Box is learning new things. I've had some, but limited, experience with LED on PCB, so I think I'll tear apart a boom box or something to practice on. I looked for porscheleds.com, but get an error. Do you have an alternate address?

The sites I did find list voltage as 3.0-3.5VDC, but you said the CC is 1.5VDC. Am I looking at the correct LEDs, or will 3V ones work? These won't need a resistor, but the speedo/tach are 12V, so they will, correct?

Thanks for the supplies breakdown. Do you also have a breakdown for the rotary guages?

[Mrmaddbrad]

Originally Posted by Iflylow

I looked for porscheleds.com, but get an error. Do you have an alternate address?

This is the same website everyone uses, they must have changed their name.

http://www.sportscarleds.com/