Go Back   986 Forum - The Community for Porsche Boxster & Cayman Owners > Porsche Boxster & Cayman Forums > Boxster General Discussions

Post Reply
 
LinkBack Thread Tools Display Modes
Old 02-06-2007, 08:08 AM   #1
Registered User
 
Join Date: Jul 2004
Location: Houston, Texas
Posts: 7,243
After my new one was installed, it turns fine and there's no jiggling or fiddling with it. It may not have been installed correctly, or your new one has broken already.

They are made of cheap plastic and do break. My mechanic keeps a half dozen of them in his toolbox for the inevitable day that every single 996 and 986 customer of his calls and says that mysterious things are happening with their electrical systems.
RandallNeighbour is offline   Reply With Quote
Old 02-06-2007, 08:11 AM   #2
Registered User
 
Join Date: Jul 2006
Location: Where the Sewer Meets the Sea, CA. USA
Posts: 2,695
Send a message via MSN to CJ_Boxster
Ah ok, good stuff. I havent had one installed before but i think i might have to give it a whirl and install it. Is there a DIY writeup on the forum?
__________________
--Proud Boxster Owner/Tech,

Carlos J Cazares

FastForward Performance
http://i10.photobucket.com/albums/a1...er/newsig1.jpg
CJ_Boxster is offline   Reply With Quote
Old 02-06-2007, 09:34 AM   #3
Registered User
 
Join Date: Nov 2006
Location: central PA
Posts: 165
CJ, I can't find a writeup, so i'll take some pictures when I do mine.

Randall - KRICKEY! That guy (foreigncarpartsonline) ships fast! I ordered it when you posted the link (10:40), and I just recieved confirmation that it's shipped... That's a two hour turn around time.. Awesome!

Thanks again!
Wonko The Sane is offline   Reply With Quote
Old 02-06-2007, 10:56 AM   #4
Registered User
 
Join Date: Nov 2006
Location: In the garage...
Posts: 1,737
Here's a link to a write up

Wonko-
Save your write up time for driving. Here's a link to one already done. The part #s may have changed since this was written, but the procedure is the same - EXCEPT you should not need to remove the drivers seat - just contort yourself like hell to get up in there. Good luck!

http://www.industryfigure.com/berkeley/Porsche/ignitionswitch.htm

BTW, with the really cold temps and a bad ignition switch, it's a good idea to throw your battery maintainer on the car until you fix the switch.

Here's a one page write up w/ out as much details, but again, good 'nuff (courtesy of Tool Pants on RennTech)


Last edited by Burg Boxster; 02-06-2007 at 11:18 AM.
Burg Boxster is offline   Reply With Quote
Old 02-06-2007, 11:27 AM   #5
Registered User
 
Join Date: Nov 2006
Location: central PA
Posts: 165
Thanks Burg... I'll use the time to throw down the top and go for a spi..... . oh, wait, no, it's bloody cold... I'll use the time to sit inside and wish it was warm enough to throw the top down to go for a ride
Wonko The Sane is offline   Reply With Quote
Old 02-06-2007, 11:42 AM   #6
Registered User
 
Join Date: Jan 2007
Location: California
Posts: 40
I have an 02 where I just noticed that the raido stays on for a couple of seconds after the key is withdrawn, then cuts off. I think this is normal. What I think is not noraml is that I can turn the radio back on without the key in the ignition. Any thoughts? I wasn't trying to hijack, the issue is similar as the original poster. Sometimes I too have to jiggle the key once its inserted into the ignition to get it to turn. Should I replace the ignition switch?

jeff

Last edited by jl1252; 02-06-2007 at 11:46 AM.
jl1252 is offline   Reply With Quote
Old 02-06-2007, 01:03 PM   #7
Registered User
 
Join Date: Aug 2006
Location: NJ
Posts: 195
the radio can be turned on while the key is out...that is normal.
__________________
http://home.comcast.net/~jmpfleet/Cars/m3r.JPG
Current - 04' M3 SMG Convertible
SOLD - But never to be forgotten 98 Boxster
Stock w/19" Wheels, stealth K40 front and rear
Boxter is offline   Reply With Quote
Old 02-06-2007, 01:27 PM   #8
Registered User
 
Join Date: Jan 2007
Location: California
Posts: 40
Quote:
Originally Posted by Boxter
the radio can be turned on while the key is out...that is normal.

Thanks for replying. That is good to hear. I guess I'll wait till I have other symptoms before I replace the ignition switch.

Jeff
jl1252 is offline   Reply With Quote
Post Reply



Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -8. The time now is 02:04 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0
Copyright 2025 Pelican Parts, LLC - Posts may be archived for display on the Pelican Parts Website -    DMCA Registered Agent Contact Page